After this lesson
- Insert a corner from the top layer
- Recognise and fix a twisted corner in the slot
- Complete the first layer reliably
Position, then insert
Take a white corner in the top layer and look at its two side colours. Turn the top layer until the corner sits directly above the slot between those two centres. The corner is now above its home.
Apply the trigger R U R' U' until the corner drops in. In the common case it takes one to three repetitions. Do not rotate the cube between repetitions; read the result and continue.
R U R' U'
The corner-insertion trigger. If the corner is already in the slot but twisted, apply it once to lift the corner out.
The three corner states
- White facing up: the corner is easy to align; one or more triggers will insert it.
- White facing a side: the corner needs to be turned; keep applying the trigger and watch the slot.
- Corner already in the slot but twisted: apply the trigger to remove it, then solve it normally.
Do not break the cross
The trigger R U R' U' only affects the right layer and the top layer, so a completed cross on the bottom stays intact. If you use a different sequence that turns F or B, double-check that the cross edges are restored at the end.
Work around the cube with one hand on the bottom layer. The fewer regrips you make, the easier the next layer will be.
If the first layer looks complete but the side colours do not form a solid band, a corner is in the wrong slot. Take it out and reinsert it above the correct pair of centres.
Check your understanding
1. How many white stickers should be on the bottom face after the first layer?
2. What should you do if a white corner is in the slot but twisted?
3. Which trigger is used for first-layer corners?