After this lesson
- Complete the white cross from any scramble
- Check side-colour alignment without guessing
- Avoid the most common cross mistakes
The target state
A finished cross has four white edges around the white centre, and each edge's second colour matches the centre of the side it touches. A cross with four white stickers but mismatched side colours is not finished. The side colours are the part that matters.
A simple procedure
- Find a white edge in the top layer.
- Match its side colour to the corresponding centre.
- Turn that side 180° to drop the edge into the bottom layer.
- Repeat for the other three edges.
- If an edge is stuck in the wrong bottom slot, bring it up with a face turn, align it, and reinsert it.
F' U' F
One way to lift a front-layer edge into the top layer before aligning it.
The mistakes that cost the most
- Solving white on top, then turning the cube over — this makes the first layer harder to inspect.
- Ignoring the side colours and only looking at white.
- Breaking a solved cross edge while inserting another. Insert into the top layer first, then move the solved edge out of the way.
- Rotating the whole cube to find a case instead of turning the top layer.
Check yourself
Hold the cube with white down. Look at the four side faces: each should show a white edge sticker and the matching centre colour directly below it. If one side is wrong, the edge is in the wrong slot, even if the white sticker is on the bottom.
Practise the cross with a 15-second inspection. Plan all four edges before you turn. This is the beginning of CFOP cross planning.
Check your understanding
1. What must match on a completed white cross?
2. Where should the white cross be for the beginner method?
3. An edge is in the bottom layer but in the wrong slot. What should you do?